Serving Salt Lake City and the Salt Lake Valley since 2006
Licensed & InsuredFree EstimatesMon-Fri 7am-6pm
(385) 622-8922 Licensed & Insured
Get a Free Floor Estimate

Epoxy Flooring in Sandy, UT

Salt Lake City Superior Epoxy Flooring provides professional epoxy flooring in Sandy, UT. Our crews install epoxy garage floor coatings, flake epoxy floors, one-day polyaspartic systems, basement floor epoxy, metallic epoxy and polished concrete, plus epoxy floor repair and recoating. We grind every slab to ICRI CSP 2-3, and our flake systems build about 25 mils.

Sandy had 96,904 residents at the 2020 census, and it sits right where the valley floor meets the Wasatch. East Sandy climbs the slopes of the range while the west side runs flat toward the Jordan River, and the floors we coat change with that.

Free Estimate in Sandy

Or call (385) 622-8922

Canyon Snow, Ski Gear and Sandy Garages

SR-209 runs east out of Sandy into Little Cottonwood Canyon and ends at Alta. Powder days send cars home packed with snow and brine, and wet skis and boots get stood against the garage wall. On bare concrete, that meltwater and salt soak right into the slab.

A full-broadcast flake floor under a polyaspartic topcoat stops it at the surface. The chip texture gives boots grip on a wet floor, and we add aluminum oxide grit to the topcoat if you ask. Stem walls up to 12 inches tall, right where the ski racks drip, are coated at no charge.

Expect some white crust by the door in January. A Sandy homeowner once called us sure the floor was failing, and it was three weeks of dried brine from two cars. A squeegee, a rinse and a pH-neutral cleaner fixed it, and the coating underneath was fine.

Cold matters too. From November through March, unheated garages get our one-day polyaspartic system, which goes down on a slab as cold as 40°F. You park in 24 hours, or 48 when the slab is under 50°F.

Basement Floors in Sandy's 1960s and 1970s Neighbourhoods

Sandy stayed a small town until a second boom in the late 1960s. Through the 1970s, neighbourhoods spread out in every direction from the old center at Main and Center streets, and a lot of those basements are now family rooms, storage or home gyms.

Every basement gets a free moisture test before we quote. We use ASTM F1869 calcium chloride domes for 60 to 72 hours or ASTM F2170 RH probes set at 40% of slab depth. Over 3 lbs or 80% RH, a moisture-mitigating epoxy primer goes down first.

Older basement slabs come with carpet glue, tack strip holes and paint. We grind all of it off on HEPA extraction, so the dust stays out of the rest of the house. A basement of about 800 sq ft runs $4,000 to $6,800, plus $1,200 to $2,400 if the primer is needed.

Finished family rooms often get metallic epoxy at $9 to $14 per sq ft, a design floor with no grout lines. Storage and laundry rooms usually get solid-color epoxy or flake.

Epoxy and Polished Floors We Install in Sandy

Polished Concrete and Commercial Floors Near Sandy's City Center

Sandy's commercial side keeps growing. The Cairns, the walkable city center laid out in a master plan the city adopted in January 2017, stretches between 9000 South and 11400 South, with offices, retail and apartments around the Shops at South Town and the Mountain America Exposition Center.

Offices, lobbies and retail floors in buildings like these suit polished concrete at $3.50 to $8 per sq ft, with no coating to wear through. Restrooms and break rooms get quartz broadcast epoxy, and restaurant kitchens get urethane cement with an integral cove base, installed on nights and weekends at no surcharge.

We run the same crews between Sandy and South Jordan, UT most weeks, so lead times stay at 7 to 14 days across the south end of the valley.

What to Expect From Our Crew in Sandy

Give us a call at (385) 622-8922 and we'll call you back within 2 business hours. You'll get an on-site estimate from Jared or our estimator within 3 business days. We email your itemized quote the same day we visit.

On install day we grind to CSP 2-3, chase and fill cracks, patch spalls and grind every repair flush. Then the base coat, flake broadcast to rejection and the polyaspartic topcoat go down.

We're licensed through the Utah Division of Professional Licensing (DOPL) and insured. Residential flake and polyaspartic floors carry a 15-year written warranty against peeling, delamination and hot-tire pickup.

Sandy Epoxy Flooring Questions

Can you coat a garage floor where we store ski gear?

Yes, and it's one of the best uses for flake. The texture grips wet boots, the polyaspartic topcoat sheds meltwater, and stem walls under the ski racks are coated free up to 12 inches.

Is the white crust on my coated garage floor a problem?

Hardly ever. In Sandy winters, that white crust is usually just dried road salt brine. Squeegee the area, rinse it, and use a pH-neutral cleaner. Call us if the coating is actually lifting at the edges.

Can you epoxy a finished basement floor in an older Sandy home?

Yes, after a free moisture test. Carpet glue and paint get ground off first, and if the slab reads high, the mitigating primer goes in before the color coat.

Do you polish concrete in commercial spaces in Sandy?

Yes. We polish office, lobby and retail floors to 800 grit, or 1,500 to 3,000 for high gloss, and work nights and weekends so the space stays open.

How long does a Sandy garage floor take?

A one-day polyaspartic floor takes 1 day and you park in 24 hours. An epoxy-base flake floor takes 2 days, with parking at 72 hours.

Book an Epoxy Floor Estimate in Sandy

Give us a call at (385) 622-8922 or fill in the form. We return calls within 2 business hours, Mon-Fri 7am-6pm, and send the quote by email the day of the visit.