Serving Salt Lake City and the Salt Lake Valley since 2006
Licensed & InsuredFree EstimatesMon-Fri 7am-6pm
(385) 622-8922 Licensed & Insured
Get a Free Floor Estimate
Epoxy Floor Repair and Recoating in Salt Lake City, UT

Epoxy Floor Repair and Recoating in Salt Lake City, UT

Salt Lake City Superior Epoxy Flooring offers professional epoxy floor repair and recoating in Salt Lake City, UT with 20 years of experience fixing coatings, including plenty we didn't put down. We repair hot-tire peel, chipped and gouged spots, yellowed epoxy and failed box-store kits, and we recoat sound floors that just need a fresh topcoat. Failed coatings get ground off to bare concrete before anything new goes on.

Spot repairs run $350 to $900 a visit, and the color match is close, never perfect. When a floor is lifting at the edges or peeling in sheets, a strip and recoat at $6.50 to $9.50 per sq ft is the honest answer, and it carries the same 15-year warranty as a new flake floor. Spot repairs carry a 1-year warranty.

Get a FREE Estimate

Or call (385) 622-8922

  • We find out why it failed, not just where
  • Old coating ground off, never coated over
  • Full strip and recoat backed for 15 years
  • We'll tell you when a mop is the fix

Epoxy Floor Repair and Recoating Services

Most repair calls fall into one of five groups. The first visit tells us which one you've got.

Hot-Tire Peel Repair

Hot-Tire Peel Repair

Tire-shaped bare patches mean the coating bonded to your tires better than to the slab. We grind out the failed area past the edge of the peel, feather it, and rebuild with base coat, flake and topcoat. If peel shows up in more than a couple of spots, the whole floor usually has the same weak bond.

Chip, Gouge and Impact Repair

Chip, Gouge and Impact Repair

A dropped jack stand or a dragged snowblower can chip a sound floor. We grind out the damaged spot, fill it with epoxy mortar if the concrete is damaged too, and recoat it to blend. Each spot repair visit runs $350 to $900.

Strip and Recoat Over Failed Coatings

Strip and Recoat Over Failed Coatings

Peeling kits, bubbled basement coatings and floors that lift when you scrape the edge get ground off completely to bare concrete. Then we install a new system from the CSP 2-3 profile up. It runs $6.50 to $9.50 per sq ft, grinding included.

Topcoat Refresh for Worn Floors

Topcoat Refresh for Worn Floors

A floor that's well bonded but worn dull in the tire paths can take a new clear coat. We abrade the old topcoat, clean it and roll on fresh polyaspartic. It's priced per job once we've checked the bond.

Yellowed Epoxy Restoration

Yellowed Epoxy Restoration

Epoxy floors without a UV-stable top amber near the garage door over a few summers. If the floor is still bonded, we abrade it and add an aliphatic polyaspartic topcoat in a tinted or clear finish. If it's also peeling, it's a strip and recoat.

Before and After

Peeling DIY epoxy garage floor with hot-tire marks in a Taylorsville, Utah home
Garage recoated with gray and black flake epoxy after removing a failed DIY kit
Typical before and after: a peeling DIY garage floor kit with hot-tire lift stripped and recoated in flake epoxy.

Why Epoxy Floors Fail: What We Find on Repair Calls

No grind is the big one. A coating rolled onto an acid-etched or unprepared slab has no mechanical profile to hold, so it lets go at the edges and under hot tires first. We see it most on box-store kits and on cheap installs.

Thin film is next. A water-based kit dries to roughly 2 to 3 mils, which can't resist hot tires, brine or dropped tools for long. Moisture is third: a basement or slab-on-grade coated without a test can blister from vapor pushing up from below.

Cold cure and contamination round it out. Epoxy rolled onto a slab under 55°F can cure soft, and oil soaked into the concrete before coating keeps the floor from bonding over that spot. Each cause leaves a different pattern, which is why we look at where the floor failed before we talk about fixing it. Edges and tire paths point to prep, scattered blisters point to moisture, and soft or tacky patches point to a cold install.

Repair, Recoat or Strip: How We Decide

We use a scraper and a hammer to check the bond. If the coating lifts at the edges, sounds hollow, or peels in sheets, the bond failed. You can't just patch a floor like that. We'll strip it.

If the bond is solid and the damage is local, a spot repair makes sense. If the bond is solid but the whole surface is worn or yellowed, a topcoat refresh does it for a lot less than starting over.

We show you what we find before we quote. Sometimes a homeowner wants a spot repair to get through a home sale or one more winter, and that's fair. We'll just be clear that it's a stopgap at $350 to $900 a visit, and that a 1-year warranty is what comes with it.

Problems That Look Like Failure but Aren't

White crust by the garage door in January is almost always dried road salt brine, not a failed coating. Squeegee it out, rinse, and mop with a pH-neutral cleaner, and the floor underneath is usually fine.

A three-year-old floor that just looks dull usually needs cleaning, not recoating. Soap-based cleaners and hard water leave a film that flattens the gloss. A pH-neutral cleaner and a microfiber mop often bring it right back.

We've driven out for repair calls and left without a job because a mop fixed it. That's fine with us. Give us a call and describe what you're seeing, and we'll tell you if it's worth a visit.

Repairing Floors Somebody Else Installed

Most of our repair work is on floors we didn't install. We can't always know which product is down there, so we test the bond and adhesion before we patch, and if the old system is a mystery, a strip and recoat is the safer bet.

When we strip a floor, the new one is ours from the concrete up, including the CSP 2-3 grind, the crack repair and every coat. That's why a full strip and recoat carries our full 15-year warranty against peeling, delamination and hot-tire pickup, the same as a new floor.

Get Your Epoxy Floor Looked At

Call (385) 622-8922 or describe the problem in the form. We'll tell you if it needs a spot repair, a recoat, a full strip, or just a good cleaning.